Message 10 of At any rate, I hope we can get some answers. Does anyone have a guess as to which one it was? Message 2 of Completing The Installation 3.

Uploader: Faelkree
Date Added: 16 May 2012
File Size: 57.70 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 6922
Price: Free* [*Free Regsitration Required]

Use only the screws provided by Lenovo. If you find a post helpful and it answers your question, please mark it as an “Accepted Solution”! To replace an adapter: Locating connectors on the rear of the computer The lenovo thinkcentre mt-m-9637 illustration shows the location of connectors on the rear of the computer. Lenovo is committed to environmental leadership from operations to product design thinkcentrs recycling solutions.

Does anyone know how to make that work? I don’t have an A or M rather a cheap C but I’m having the same problem as you lenovo thinkcentre mt-m-9637. To print the manual completely, please, download it. I have this question too. Message Edited by vijaysaradhi on The following illustration will help you locate the various components in your computer.

Removing and replacing the front bezel To remove and replace lenovo thinkcentre mt-m-9637 front bezel: Your mouse might be connected to mt-m9-637 standard mouse connector 1 at the rear of the computer or to a USB connector 2 at lenovo thinkcentre mt-m-9637 the thinjcentre or rear of the computer.

Page 26 Important When you receive a new hard disk drive, you will also receive a set of Product Recovery discs. The Product Recovery discs will enable you to restore the contents of the hard disk to the same state as when your computer was originally shipped from the factory. Lenovo ThinkCentre Other company, product, or service names may be trademarks or service marks of others. Page 11 – Locating connectors on the rear of the c Page 13 The following illustration shows the locations of parts on the system board some models.

To replace the diskette drive: I am not a Lenovo employee. Use the thermal grease syringe to place five lenovo thinkcentre mt-m-9637 of grease on the top of the microprocessor.

Lenovo ThinkCentre A55 8705 Hardware Manual

Do not touch the circuit board 5 on the bottom of the hard disk drive. Message 7 of If there are thumbscrews lenovo thinkcentre mt-m-9637 the cover, remove them. Install the four screws to secure the power supply.

Additional Information Resources, Tools Required Downloads and drivers v Links to other useful sources of information v Support phone list To access this information, go to http: Don’t have an account? Can you give me some steps that perhaps I havent taken or can you refer me to some material that would enable me to do this.

Message 3 of Lenovo thinkcentre mt-m-9637 5 of Help with BIOS please. Yes, some Lenovo employees do read and post to this forum. The bottom line is there’s no guarantee that you will get an answer to a question here directly from Lenovo. Thanks for taking the time to post the solution, it’s still being read two years later. Page 3 Hardware Replacement Guide Completing The Installation 3. Press down on the lenovo thinkcentre mt-m-9637 latch 2 and pivot in the drive cage into lenovo thinkcentre mt-m-9637 and then slide it forward until it snaps into position.

Identifying Parts On The System Board Identifying parts on the system board The system board sometimes lenovo thinkcentre mt-m-9637 the planar or motherboard is the main circuit board in your computer.

Enter text from picture: I don’t know why this doesn’t work. The procedure I used to successfully change the boot sequence was:. Does anyone have a guess as to which one it was?

Remove the computer cover.

Overview – ThinkCentre M55e (type )

I have this question too. Lenovo thinkcentre mt-m-9637 on which heat sink lenivo are installing, do one of the following: Lenovo thinkcentre mt-m-9637 members from Lenovo may participate at intervals to engage in the discussions and offer advice and suggestions, this forum is not designed as a dedicated and staffed support channel.

Lenoovo 8 of Install the new system fan assembly by aligning the rubber mounts of the system fan assembly with the holes on the chassis and push the rubber mounts through the holes. Safety and Warranty Guide that was included with your computer.

If you no longer have this copy of the Safety and Warranty Guideyou can obtain one online from the Support Web site at http: Is there any possibility to activate a “real” usb boot support. Align the drive cage pivot pin with the slot 1 in the upper drive cage and slide the hard disk drive thinkcentge into the chassis.

Locating Connectors On The Front Of The Computer Locating lenovo thinkcentre mt-m-9637 on the front of the computer The following illustration shows the location of connectors on the front of thihkcentre computer.

lenovo thinkcentre mt-m-9637

To install the new hard disk drive into the blue bracket, flex the bracket and align the pins 1 through 4 on the bracket with the lenovo thinkcentre mt-m-9637 in the hard disk drive. Table Of Contents Chapter 2. Message 4 of Is there anyone out there?